1. Support
  2. Printers
  3. Lexmark Forms Printer 2591+
  4. Interactive user guide
  5. Lexmark 25xx+ Forms (Dot Matrix) Printer ? How to Properly Install the Ribbon Cartridge and Carrier Unit
Lexmark Forms Printer 2591+

Lexmark Forms Printer 2591+

Printer features: Dot matrix

Lexmark Forms Printer 2591+ Support

Lexmark 25xx+ Forms (Dot Matrix) Printer ? How to Properly Install the Ribbon Cartridge and Carrier Unit

Overview
This document describes the proper way of installing a replacement ribbon cartridge in the Lexmark
258x+
&
259x+ Forms
printer models.
In some cases, incorrect fitting of the cartridge may result in the carrier unit being dislodged. Should this happen, the subsequent procedure describes how to re-seat the carrier unit.
How to remove and replace the ribbon cartridge
Step
Action
1
Lift the left and right release latches on the ribbon access cover to remove it. Place the ribbon access cover on a flat surface.
2
Squeeze the left and right latches on the ribbon cartridge to lift it out of the printer.
3
Place the new ribbon cartridge on top of the carrier unit.
4
Turn the ribbon advance knob and make sure that the ribbon is not caught in the carrier unit.
5
Squeeze the ribbon cartridge's left and right latches and then press them down evenly on both sides. Ensure that the cartridge is seated firmly.
Note:
The video below will demonstrate the proper installation of the ribbon cartridge.
IMPORTANT!
You need
QuickTime
to be able to play the video file. Click the button
to download QuickTime now.
A pop-up message might appear saying "
QuickTime Player needs your permission to run
". Click "Always run on this site."
Click the Play button to watch the video

How to Fix a Dislodged Carrier Unit
Follow the procedure below to reinstall the carrier unit in the event that it has been dislodged, (such as shown in the image below).
Click Image to Enlarge
Step
Action
Click Image to Enlarge
1
Using your left and right index fingers, press the retaining clips on both sides of the carrier unit.
2
Check the retaining clips on the left and right-hand side of the carrier unit and make sure that they are seated firmly on the carriage.
3
The side view of a fully installed carrier unit should look as in the right-hand image.
Note:
Watch a quick demonstration of the above steps by playing the video below.
Click the Play button to watch the video

Still need help?
If you require additional assistance, please close this window and locate
Get In Touch with Lexmark!
for contact information.
NOTE:
When calling for support, you will need your
printer model
/
machine type
and
serial number
(
SN
). If you need help locating these, GUID-e17e2b5a-612f-450b-9ee4-c6dfd9f75377-en.dita#how-to-locate-the-serial-number-on-a-lexmark-24xx25xx25xx-series_how-to-locate-the-serial-number-on-a-lexmark-24xx25xx25xx-series.
Please be near the products described in this article to expedite the support process and reduce callbacks.
LEGACY ID:
HO3945