PCL

Menu item	Settings	Description
Font Source	Resident * Disk Download Flash Font Card All	Select the source which contains the default font selection. Disk —appears only and if a non‑defective, non‑read/write protected hard disk that contains fonts is installed. Download —appears only if downloaded fonts exist in the printer memory. Flash —appears only if a non‑defective, non‑read/write protected flash memory that contains fonts is installed. Font Card —appears only if a valid font card is installed or an intelligent storage drive is configured.
Font Name	[List of available fonts] ( Courier *)	Select a font from the specified font source.
Symbol Set	[List of available symbol sets] ( 10U PC‑8 *)	Specify the symbol set for each font name. A symbol set is a set of alphabetic and numeric characters, punctuation, and special symbols. Symbol sets support the different languages or specific programs such as math symbols for scientific text.
Pitch	0.08–100.00 (10.00*)	Specify the pitch for fixed or monospaced fonts. This menu item refers to the number of fixed‑space characters in a horizontal inch of type.
Orientation	Portrait * Landscape Reverse Portrait Reverse Landscape	Specify the orientation of text and graphics on the page.
Lines per Page	1–255	Specify the number of lines of text for each page printed through the PCL® data stream. This menu item activates vertical escapement that causes the selected number of requested lines to print between the default margins of the page. 60 is the U.S. factory default setting. 64 is the international factory default setting.
PCL5 Minimum Line Width	1–30 (2*)	Set the initial minimum stroke width value of any job printed in 1200 dpi through the applicable emulator.
PCLXL Minimum Line Width	1–30 (2*)
A4 Width	198 mm * 203 mm	Set the width of the logical page on A4‑size paper. Logical page is the space on the physical page where data is printed.
Auto CR after LF	On Off *	Set the printer to perform a carriage return after a line feed control command. Carriage return is a mechanism that commands the printer to move the position of the cursor to the first position on the same line.
Auto LF after CR	On Off *	Set the printer to perform a line feed after a carriage return control command.
Tray Renumber	Assign MP Feeder Assign Tray [x] Assign Manual Paper Assign Manual Envelope	Configure the printer to work with a different print driver or custom application that uses a different set of source assignments to request a given paper source. Choose from the following options: Off —The printer uses the factory default paper source assignments. None —The paper source ignores the Select Paper Feed command. 0–199* —Select a numeric value to assign a custom value to a paper source.
	View Factory Defaults	Show the factory default value assigned for each paper source.
	Restore Defaults	Restore the tray renumber values to their factory defaults.
Print Timeout	Off On * (90)	Set the printer to end a print job after it has been idle for the specified amount of time.

An asterisk (*) next to a value indicates the factory default setting.