Change the USB driver mode of the printer to improve its compatibility with a personal computer.

Set whether the USB device driver enumerates as a USB Simple device (single interface) or as a USB Composite device (multiple interfaces).

Set the USB port to run at full speed and disable its high‑speed capabilities.

Set the printer to link the trays that have the same paper type and paper size settings.

Display a message to select paper size and type after inserting the tray.

Specify the page orientation when loading A5 paper size.

Set the paper source that the user fills when a prompt to load paper appears.

Set the paper source that the user fills when a prompt to load envelope appears.

Set the printer to resolve paper- or envelope-related change prompts.

Print reports about printer menu settings, status, and event logs.

Reset the supply usage history, such as number of pages and days remaining, to the factory shipped level.

Reset the counter after installing a new supply.

Set the printer to recognize and use the PPDS data stream.

Set the printer to recognize and use the PS data stream.

Set the page timeout during emulation.

Reset the emulator after a print job.

Disable access to the printer message during emulation.

Set fax to enter Sleep mode whenever the printer determines that it should.

Print color content in grayscale.

Enhance the printed output to compensate for misregistration in the printer.

Set a text point-size value below which the high‑frequency screens are used when printing font data.

For example, if the value is 24, then all fonts sized 24 points or less use the high‑frequency screens.

Set the printer to operate in Quiet Mode.

Enable access to the control panel menus.

Set the printer to operate in a special mode, in which it attempts to continue offering as much functionality as possible, despite known issues.

For example, when set to On, and the duplex motor is nonfunctional, the printer performs one‑sided printing of the documents even if the job is two‑sided printing.

Erase user‑defined strings for the Default or Alternate custom messages.

Erase messages that were remotely installed.

Show existing error messages on the display after the printer remains inactive on the home screen for a length of time equal to the Screen Timeout setting.

Set the default calibration frequency.

Run the full color calibration.

Print a diagnostic page that contains toner patch sensor calibration.

Print a Quick Test target page.

Manually register the flatbed and ADF after replacing the ADF, scanner glass, or controller board.

Set the size, in millimeters, of the no‑print area around an ADF or flatbed scan job.

Disable the scanner when it is not working properly.

Set the byte order of a TIFF‑formatted scan output.

Set the RowsPerStrip tag value of a TIFF‑formatted scan output.