Configuring TCP/IP settings via the control panel

Need to configure TCP/IP settings? Check out the following instructions on how to do so via the control panel.

This document details the different ways to configure the TCP/IP settings on a printer’s control panel.

2.4" (6.1cm) Models Without A Touchscreen

Make sure that the printer is powered on and that the Ready
message is showing.

Press the Menu
button.

Press the Right Button
next to Network/Ports
.

Press the Right Button
next to Std Network
.

Press the Right Button
next to Network Setup
.

Press the Right Button
next to TCP/IP
.

Press the Right Button
next to the IP Address
.

Using the number pad or arrows on the device, configure your static IP address.

Example:

Press Left Button
to count down from 255.

Press Right Button
to count up from 0.

Press Check
to jump to the next octet.

Press Check
to save the address. An asterisk (*) at the end of the IP address confirms that the settings are saved.

4.3", 7", and 10" (10.9, 17.8, 25.4cm) Touchscreen Models

Repeat this procedure for IP Address
, Netmask
, and Gateway
configuration.

Press the Menu
button.

Press the Right Button
next to Network/Ports
.

Press the Right Button
next to Standard Network
.

Press the Right Button
next to STD NET SETUP
.

You might see Network 1 SETUP
if using the Wireless Network Card option.

Press the Right Button
next to TCP/IP
.

Press the Right Button
next to IP Address
.

Enter IP address values using the numeric keypad and then press Submit
.

LEGACY ID: HO3900