Article de support pour Lexmark X860
How to install the IEEE-1284B Parallel ISP option card
Overview
Make sure that no held jobs are present in the print queue. Then power off the device. Remove the left-hand access door and remove the metal shield that a Phillips screw holds in place.
Note: Failure to remove held jobs may result in a 57 Configuration change, some held jobs were not restored message. Lost jobs are not recoverable.
Installing ISP* option (Parallel card example)
Other card types: MarkNet N8230 Fiber, the External RS-232Cserial option, and other supported options all install in a similar manner. CS/CX 92x illustration showing installed ISP 'MarkNet option'
| Step | Action |
|---|---|
1 | Remove the IEEE-1284B Parallel Option card from its package and confirm the shipped contents:
ISP* - Internal solutions port |
2 Required if HD present | If a hard drive (HD) is present on the printer, you will need to remove the existing hard drive from the device before proceeding. To do this:
 Note: If your printer does not contain a hard drive, you will still have to remove the two screws from the option card slot on the back of the printer.  |
3 Required if HD present | Remove the hard drive. Observe the location of the three mounting posts and the corresponding mounting hole positions on the system board.  |
4 | If the purchased option provides a T-bracket, then snap it into place.  |
5 | Slide the card into preliminary position. Start the upper bracket thumb screw into the T- bracket, but do not tighten it all the way. Suggestion: Do not install the lower bracket thumb screw at this time for alignment purposes. Also, the bail clips should stick straight out to allow passage through the card cage slot.  |
6 | Center and insert the top slot screw. Also, make sure the bottom of the card is center-aligned with the the control cage's screw position.  |
7 | Place the parallel card onto the T-bracket and secure this card with the longer thumbscrew that has been included. Note: Do not over tighten; and make sure the card is centered in the bracket.   |
8 | Insert and tighten both lower-bracket thumb screw and lower-slot screw. Lower-slot screw illustration.  |
9 | Lastly, connect the card's blue cable connector to the system board socket labeled INA or ISP.  |
10 Required if HD present | If you are reinstalling the hard drive, align the hard drive mounting posts with the corresponding card holes. Then snap the hard drive back into place.  |
11 Required if HD present | Connect the hard drive cable connector to the blue socket on the parallel card labeled HDD.  |
12 | Replace all covers. |
LEGACY ID: HO3629
Noter cet article
Vos commentaires sont les bienvenus. Les commentaires nous aident à identifier les contenus qui doivent être actualisés pour plus de précision ou de fidélité.
Merci de votre commentaire!