Support article for Lexmark B2546
Unboxing and Initial Setup Results in a 200.91B Error
Affected products
Click
Properties
in the title bar above.
What you will see
Initial power-up of the printer results in a 200.91B error.
Solution
Make sure all packaging material is removed from the Imaging Unit.
To do this:
Open the front door.
Remove the toner cartridge bottle.
Remove the Imaging Unit.
Remove any packaging material from Imaging Unit that may not have been removed, e.g., foam blanket, red shipping separator, and/or handtag.
Reinsert all supplies and close the door.
Power on the device and it should now be READY.
Explanation
A covered input sensor triggers this error. It is most frequently observed when packing materials have not been fully removed and the printer is powered ON.
Still need help?
If you need additional assistance, please close this browser tab or go to the Lexmark support site, type your printer model and locate
NOTE: When calling for support, you will need the following:
- Affected printer model/s
- Printer serial number
Please be near the product/s described in this article to expedite the support process and reduce callbacks.
LEGACY ID: TE885