Thank you for your feedback



Lexmark X95x MFP – 843.05 and 900.58 Error Code

Document ID:TE428
 
  Properties  

Problem

Lexmark X95x MFP – 843.05 and 900.58 error code; 843.05 error; 900.05 error; Error 843.05; Error 900.05; 843.05 error appears when scanning on the ADF; 900.05 error appears when scanning on the flatbed; Unable to scan; Unable to copy; 843.05 error appears when copying; 900.05 error appears when copying; The scanner lamp moves only 2 inches when scanning; The scanner lamp moves only 2 inches when copying; the machine will scan the first page only and then post the 843.05 error code; Unable to scan the second page; Auto document feeder; ADF

Solution

What you will see

 

  • Using the Auto Document Feeder (ADF) to copy, the machine will scan the first page and then post the 843.05 error code.
     
  • Using the flatbed scanner to copy, the scanner lamp only moves about two inches (five cm) when a scan is initiated, and then posts the 900.58 error code.

 

 

Troubleshooting

 

Clear the error by powering off the printer. Wait ten to 20 seconds before powering it back on. Run a test scan and see whether the error reappears.

  • If the error did not reappear after a couple of test scans, continue using the machine but observe its operation for a week. If no further sign of the error develops, it was probably a temporary glitch; restarting the machine cleared it.
     
  • If the error re-appears, contact Lexmark Technical Support to set up service for the printer.

 

 

Still need help?

 

Please contact Lexmark Technical Support if you need additional assistance. NOTE: When calling for support, you will be asked for your machine/model type and serial number (SN).

Please call from near the printer in case the technician on the phone asks you to perform a task involving the printer.

 

 



Link:
Please enter the email address you would like to send a copy of this page to.