How to Update the Lexmark N7000 Series Print Servers Using a USB Flash/Jump Drive
|Lexmark MarkNet N7000e||Lexmark MarkNet N7002e||Lexmark MarkNet N7020e|
Before you begin, do the following:
- - Download the firmware from Lexmark.com.
- - Extract the .zip file
- - Copy the *.ffc file to a flash drive. (The example below uses the LLCON0N53.ffc file.)
NOTE: This procedure applies to MarkNet N7000e and MarkNet N7020e only. The firmware level may have changed since the release of this article.
1st line/Second Line of LCD
Step Action 1 Insert the USB flash drive into an available USB port. 2
Press when USB Mass Storage Device/Media Drive is displayed on the LCD.
MarkNet N7020e users:
Press or until USB Mass Storage Device/Media Drive is displayed on the LCD, and then press .
3 Press or to locate the *.ffc file - for example, Media Drive/LLON0N53.ffc. 4 Press . 5 Press again at Options:/Update Firmware. 6 Observe Updating/Do Not Power Off. 7
Near the end of the firmware update, you should see a CRC OK message followed by:
- Kernel... loading to 100%
- Base... loading to 100%
- Net... loading to 100%
- NetDrv... loading to 100%
CRC = Cyclic Redundancy Check
8 The network adapter (print server) will reboot and you will see the new firmware level displayed on the LCD.
Please contact Lexmark Technical Support for additional assistance. NOTE: When calling for support, you will need to know your printer model type and serial number.
Please call from near the print server in case the technician asks you to perform a task involving the device.