Before you begin
IMPORTANT! If you have an active USB cable connection, disconnect the USB cable from the back of the printer before performing this procedure. Turn the printer ON .
- This printer does not support simultaneous wireless and USB connections.
- If you perform this procedure with the USB cable connected to the printer, you will print out the Printer Settings page only.
Procedure: Printing out the Settings Pages
Press the power button to put the printer into power saver mode.
|2||Observe the power button light strobe blink and the Wi-Fi light indicator turn OFF .
Press and hold the power button for 10-15 seconds.
|4||Observe the power button light turn ON and the Wi-Fi light indicator turn .
1st page – the Printer Settings Page
Printer Settings Page: Values of importance
|Code Level||MCC_J012207_01, or MCC_J021307_01|
|Page Count||Pages printed or advanced through the paper path|
Note: The colored portion of the nozzle test consists of multiple rows of short lines not depicted in this illustration. All lines should be consistent and without abnormal gaps.
Network Settings Page: Values of importance
|Setting||Default Value||Configured Values (Example)|
|Bitrate||0 Mbps (Mega bits per second)||11 Mbps (Ad hoc)
Theoretical values up to 54 Mbps and up (Infrastructure).
|End-of-Job (EOJ)||90 sec.||90 sec.|
|UAA (MAC Address)||12-digit hexadecimal hardware address. Unique hardware address used as an identifier during configuration and setup of printer.||00200002CD60|
|Firmware Version||NET.MH.N021a current as of 4/4/07||NET.MH.N021a current as of 4/4/07|
Note: This value can be set through the printer's embedded Web server (EWS), also called the printer's web page.
|Address Source||Manual||DHCP (could also show Auto IP or Manual)|
Address assigned by (DHCP-enabled) access point.
If unable to obtain a DHCP administered address, Auto IP will assign a 169.254.#.# .
Note: The IP address number varies per router or access point used.
|Netmask||255.255.255.0||255.255.255.# (most common) or 255.255.0.0 if Auto IP (ad-hoc value).|
|Gateway||IP address of router or wireless router, i.e. http ://192.168.0.1 or similar. This value is often used to access your router's web page.||192.168.0.1|
|Zero Configuration Name||Unknown||Relates to Macintosh installation.|
|BSS Type||Ad hoc (computer-to-printer). This value will change to Infrastructure after configuration with access point. Commonly known as your connection type or mode.||Infrastructure|
|SSID||Print Server (02CD60*)
* This value is unique to each individual printer. Your value will be different. Notice that this value is the last six characters of the UAA (MAC address).
|macdaddy3 (This is after configuration with an access point.)|
|Wireless Security Mode||Disabled until configured.||WPA-PSK (optionally WEP, WPA2)|
|Signal Strength||Not listed||-40dBm|
|Current Access Point||Not listed||0080C80A2236 (MAC address of the access point the print server is communicating with.)|
|Current Channel||Not listed||6|
|Pairwise Cipher||Not listed||TKIP (Part of PSK Security Mode)|
|Groupwise Cipher||Not listed||TKIP (Part of PSK Security Mode)|
|Trouble Code||Can't find Wireless Network||None|
Still need help?
Please contact Lexmark Technical Support if you need additional assistance. NOTE: When calling for support, you will be asked for your machine/model type and serial number (SN).
Please call from near the printer in case the technician on the phone asks you to perform a task involving the printer.