How to install the wireless card; Card installation; How to install the wireless print server; NIC installation; INA installation; Print adapters; Card set up; Network card install; Installation; Wireless NIC; Wi-Fi peripheral; Wireless option cards; INA; 802.11N; b/g/n card; Ethernet 802.11 b/g/n; 802.11g,b,n;
This document provides step-by-step instructions to successfully install any of the following MarkNet print servers:
Before you begin
Make sure that no held jobs are present in the print queue, then power OFF the device. Remove the left or right access door and then remove the metal shield, which is often held in place by a Phillips screw.
IMPORTANT: Failure to remove held jobs may result in a "57 Configuration change, some held jobs were not restored" message. Lost jobs will not be recoverable.
Wireless network adapter installation
Remove the option card from its package and confirm the shipped contents:
MarkNet N8150.11N b/g/n wireless print server
Card mounting bracket
If a hard drive is present on the printer, you will need to remove the existing hard drive from the device before proceeding. To do this:
a. Remove the two outside screws from the back of the printer.
b. Disconnect the existing hard drive cable from the system board.
c. Remove the two thumbscrews from the anchor plate.
Note: If your printer does not contain a hard drive, you will still have to remove the two screws from the option card slot on the back of the printer.
If you require additional assistance, please close this window, go to your product's support page and locate Get In Touch with Lexmark! for contact information. NOTE: When calling for support, you will need your printer model/machine type and serial number (SN).
Please be near the products described in this article to expedite the support process and reduce call-back situations.