Thank you for your feedback



Lexmark C9235, CS/X92x, XC92xx: Common Issues Related to Setup and Installation

Document ID:TE889

Usergroup :External
  Languages  
08/27/18 Properties  

Solution

Affected Products:

Single-function: C9235, CS921, CS923, CS927

Multifunction: CX920, CX921, CX922, CX923, CX924, CX927, XC9225, XC9235, XC9245, XC9255, XC9265

 

Issue Description:

These are all Out-of-Box (OOB) issue since they are induced during the installation of the Lexmark device.

It has been observed that there are reports of error messages and print quality defects after the setup and installation of these devices.

Specifically, induced by the incorrect installation of the device, most commonly due to the non-removal of packaging material.

Listed below is a list of the most common issues that were encountered after the installation:


Issues

Cause

824.00 Scanner motor error

Loud noise from scanner area

Scanner Packaging Screws were left on the device.
 

383.63 Finisher Error

Loud noise from Finisher option

Packaging Screw on Stapler Option not removed.
 

Print Quality Issue

202.93 Paper jam error

Packaging Shipping Clips not removed from Transfer Roller.
 

Print Quality Issue (Missing Plane)

Packaging Material not removed from Black (K) Photoconductor.


Sample print quality defects

Here are samples of potential print quality issues (PQI) when the packaging material is not removed completely from the Black (K) photoconductor.
 

 

 

 

Solutions:

The following issues can easily be resolved by checking the Lexmark device for any packaging material that was missed.

Should an end user call in for assistance, please make sure to check the following procedures and walk them through the steps of checking the areas where they might have missed a packaging material


383.63 Finisher Error / Loud Noise from Finisher Option

Make sure to remove the Packaging screw on the stapler option and follow the proper procedure when installing the stapler finisher.

   

You can find the guides in installing the Staple Finisher here, Hole Punch Booklet Finisher here, and the Staple Hole Punch Finisher here.


824.00 Scanner Motor Error / Loud Noise from the Scanner Area

Check the Scanner Packaging Screws and make sure that they are removed.


Print Quality Issue (Missing Plane)

Remove the Packaging Materials from the Black (K) Photoconductor.


202.93 Paper Jam Error / Print Quality Issue

Make sure to remove the Packaging materials located in the Second Transfer Roller.

NOTE: There are two packaging shipping clips that are found in the Second Transfer Roller.


Additional Resources:

Please check the following resources for additional instructions when setting up the printer and removing the packaging materials.

How-To Videos

Setup Sheets

 

Still Need Help?

Have the following available before calling Lexmark Technical Support;

  • Affected printer model(s)
  • Printer serial number

 



Link:
Please enter the email address you would like to send a copy of this page to.