Click Properties in the title section above.
NOTE: These are all Out-of-Box (OOB) issue since they are induced during the installation of the Lexmark device.
It has been observed that there are reports of error messages and print quality defects after the setup and installation of these devices.
Cause and explanation
These issues are induced by the incorrect installation of the device, most commonly due to the non-removal of packaging material.
Listed below is a list of the most common issues that were encountered after the installation:
|824.00 Scanner motor error
Loud noise from scanner area
|Scanner Packaging Screws were left on the device.
|383.63 Finisher Error
Loud noise from Finisher option
|Packaging Screw on Stapler Option not removed.
|Print Quality Issue
202.93 Paper jam error
|Packaging Shipping Clips not removed from Transfer Roller.
|Print Quality Issue (Missing Plane)
||Packaging Material not removed from Black (K) Photoconductor.|
Sample print quality defects
Here are samples of potential print quality issues (PQI) when the packaging material is not removed completely from the Black (K) photoconductor.
The following issues can easily be resolved by checking the Lexmark device for any packaging material that was missed.
Should an end user call in for assistance, please make sure to check the following procedures and walk them through the steps of checking the areas where they might have missed a packaging material.
Make sure to remove the Packaging screw on the stapler option and follow the proper procedure when installing the stapler finisher.
Check the Scanner Packaging Screws and make sure that they are removed.
Remove the Packaging materials from the Black (K) Photoconductor.
Make sure to remove the Packaging materials located in the Second Transfer Roller.
NOTE: There are two packaging shipping clips that are found in the Second Transfer Roller.
Please check the following resources for additional instructions when setting up the printer and removing the packaging materials.
Still need help?
If you need additional assistance, please close this browser tab or go to the Lexmark support site, type your printer model and locate Get in Touch with Lexmark! for contact information. NOTE: When calling for support, you will need the following:
- Affected printer model/'s
- Printer serial number
Please be near the product/s described in this article to expedite the support process and reduce callbacks.