Single-function: C9235, CS921, CS923, CS927
Multifunction: CX920, CX921, CX922, CX923, CX924, CX927, XC9225, XC9235, XC9245, XC9255, XC9265
These are all Out-of-Box (OOB) issue since they are induced during the installation of the Lexmark device.
It has been observed that there are reports of error messages and print quality defects after the setup and installation of these devices.
Specifically, induced by the incorrect installation of the device, most commonly due to the non-removal of packaging material.
Listed below is a list of the most common issues that were encountered after the installation:
Scanner Packaging Screws were left on the device.
Packaging Screw on Stapler Option not removed.
Packaging Shipping Clips not removed from Transfer Roller.
Packaging Material not removed from Black (K) Photoconductor.
Sample print quality defects
Here are samples of potential print quality issues (PQI) when the packaging material is not removed completely from the Black (K) photoconductor.
The following issues can easily be resolved by checking the Lexmark device for any packaging material that was missed.
Should an end user call in for assistance, please make sure to check the following procedures and walk them through the steps of checking the areas where they might have missed a packaging material
Make sure to remove the Packaging screw on the stapler option and follow the proper procedure when installing the stapler finisher.
Check the Scanner Packaging Screws and make sure that they are removed.
Remove the Packaging Materials from the Black (K) Photoconductor.
Make sure to remove the Packaging materials located in the Second Transfer Roller.
NOTE: There are two packaging shipping clips that are found in the Second Transfer Roller.
Please check the following resources for additional instructions when setting up the printer and removing the packaging materials.
Still Need Help?
Have the following available before calling Lexmark Technical Support;
- Affected printer model(s)
- Printer serial number